New to me 2.4L Bridgeport EFI no start / fuel system questions

Hi all, first post here. Just picked up an open bow Baker mod vp hull with a 2.4 Bridgeport EFI motor that was mounted on the boat but not finished being

Today, 10:10 PM

Lower unit fill plug washers

The genuine washers that go behind the fill plugs seem very expensive. My local shop charges $5 Australian. Thus seems quite ridiculous. Is there anything

Today, 10:05 PM

300X lower-drive shaft

After going 2 mph faster than I have ever been before on that basin in the lake the lower locked up, bet you can't believe that. Got it apart and the

Today, 09:34 PM

3.0 300 promax manual

does anyone have a 3.0 300 promax repair manaul on pdf could email me to print off?

Today, 09:27 PM

Ideas on a New Boat

I live on a big lake…I want a SOB <25’ good performing great rough water hull…ideas?

Today, 09:26 PM

Michial E Geisler , picture of Marve Jorgensons old red XR 02

I just saw your pm here is a picture of his old boat.

Today, 09:24 PM

Like New Trophy 25 Pitch ,Small Shaft, Small Barrel

25 Pitch early Trophy Prop. Small shaft, pressed in hub. Not Flo Torque hub. 13-3/4” diameter.

Bought new, Used once just too small

Today, 08:38 PM

Mercury Small Ear Chopper 14 X 26

Small ear Mercury Chopper part number 48-75774A-4. 14” diameter X 26” pitch.

Just out of prop shop for clean up, true up and balance. 8-9

Today, 08:32 PM

Alabama executions

Alabama wants to switch to nitrogen asphyxiation to execute convicted / sentenced prisoners. There is quit a bit of push back to this and I'm wondering

Today, 07:55 PM

90 e tech by Monty Racing

Today, 07:17 PM

Cle

Clean 2 hole freshwater CLE. 1,450. Local pickup preferred in Upstate SC. Open to shipping via freight

Today, 07:15 PM

Tricks that old racers get up to after retirement

I think I kinda jump on everybody else's threads and it's not long before they get pissed of with me, so if I do my very own thread I can't upset anyone

Today, 06:01 PM

Mercury Through The Years...

Today, 05:56 PM

Wiring trim gauge to black max mid

I have these 3 wires and want to wire up a trim gauge . Thanks I figured it out.

Today, 04:41 PM

Facts about Evinrude/Johnson racing outboards made my OMC

By Lars Strom

Starting with: Paris 6 hours 1973..OMC V6 victory over Team Mercury.

Today, 04:31 PM