Getting ready to purchase a Viper, Floor and transom was redone.
My question is the engine weight.
What is the max weight someone
Hey guys,
Usually am in the Midwest but wondering if anyone has a contact to get some work done to a FF block. Nothing wrong with it but
I laugh every time I see this.
on the hunt for this factory made steering bar for the Twister and twister 1 silo motors. Appreciate any leads you might have.
should be
NIB $225.00 Shipped Lower 48
1988-2001 (185,200,225HP) Loop Charged, Carbureted Engines w/ Quick Start & S.L.O.W. (Requires Digital
Looking for project only! Like title says. I'm in Massachusetts. 774-503-0446
Last Post By: CharlieN Today, 02:03 PMI have two new 300x skirts, Mercury part#848801A $300 each
Please call me on my cell with any questions at 773-882-8221
Carl
I have one RH 15x30 Mercury 3 blade lab cleaver flow torque hub that came with my boat. This was used on my 32 Skater that I sold, it is in very good
Last Post By: chardt Today, 12:06 PMI have two RH and one LH 14.5x34 mercury lab cleavers. They come with 1.25" mercury hd flow torque hubs. $1250 for a rh and lh, or $1,550 for all
Last Post By: chardt Today, 12:06 PMSold my Skater and would like to sell my 1.62 RH and LH Sportmaster lowers with 1.25" propshafts I had as spares for my 300X's. Both rebuilt by
Last Post By: chardt Today, 12:04 PMI have a 1984 200 that I have bolted on a one piece 2.4 exhaust plate. I have had no issues with this set up but have lower water preasure like this.
Last Post By: transomstand Today, 11:03 AMhttps://youtu.be/4Olk5AU_tfg?t=296
Last Post By: doug7488 Today, 10:39 AMBelieve it or not, this was not touched by Photoshop, except to just make it smaller to post here. The image was shot on the Great South Bay, Long Island.
Last Post By: doug7488 Today, 10:36 AMGrey, aluminum dead foot for boat. 4 Bolt pattern on bottom mounting area. Foot area measures 10 1/2 inches long. Mounting area measure 4 1/16 inches
Last Post By: Seven Lakes Marine Today, 10:05 AM
2.4L Chrome bore quesitons
Thread Starter: croSSedI have a 1985 175 block that was rebuilt less than 500 hours ago. I have it in the shop for service, the heads were removed and we've got scratched up
Last Post By: skialot2 Today, 05:23 PM