The genuine washers that go behind the fill plugs seem very expensive. My local shop charges $5 Australian. Thus seems quite ridiculous. Is there anything
Last Post By: Gilera Today, 10:05 PMAfter going 2 mph faster than I have ever been before on that basin in the lake the lower locked up, bet you can't believe that. Got it apart and the
Last Post By: Wild Bill Today, 09:34 PMdoes anyone have a 3.0 300 promax repair manaul on pdf could email me to print off?
Last Post By: Wild Bill Today, 09:27 PMI live on a big lake…I want a SOB <25’ good performing great rough water hull…ideas?
Last Post By: Greg G Today, 09:26 PMI just saw your pm here is a picture of his old boat.
Last Post By: Wild Bill Today, 09:24 PM25 Pitch early Trophy Prop. Small shaft, pressed in hub. Not Flo Torque hub. 13-3/4” diameter.
Bought new, Used once just too small
Small ear Mercury Chopper part number 48-75774A-4. 14” diameter X 26” pitch.
Just out of prop shop for clean up, true up and balance. 8-9
Alabama wants to switch to nitrogen asphyxiation to execute convicted / sentenced prisoners. There is quit a bit of push back to this and I'm wondering
Last Post By: Instigator Today, 07:55 PMI think I kinda jump on everybody else's threads and it's not long before they get pissed of with me, so if I do my very own thread I can't upset anyone
Last Post By: FUJIMO Today, 06:01 PMI have these 3 wires and want to wire up a trim gauge . Thanks I figured it out.
Last Post By: 62 bugzilla Today, 04:41 PM
By Lars Strom
Starting with: Paris 6 hours 1973..OMC V6 victory over Team Mercury.
New to me 2.4L Bridgeport EFI no start / fuel system questions
Thread Starter: mxr181Hi all, first post here. Just picked up an open bow Baker mod vp hull with a 2.4 Bridgeport EFI motor that was mounted on the boat but not finished being
Last Post By: OnPad Today, 10:19 PM