The genuine washers that go behind the fill plugs seem very expensive. My local shop charges $5 Australian. Thus seems quite ridiculous. Is there anything
Last Post By: AlliStan Today, 05:22 AM
By Lars Strom
Starting with: Paris 6 hours 1973..OMC V6 victory over Team Mercury.
I just saw your pm here is a picture of his old boat.
Last Post By: Michael J Giesler Today, 02:47 AM*New Price*
Single ram hi-po 20” mid section with 260 exhaust/adapter plate. Relieved can at base and someone drilled two holes out
I was told that after 1980, i addition to the location of starboard transom v i n #, there is second set of numbers, in a undisclosed location somewhere
Last Post By: skialot2 Today, 02:19 AMAlways thought the idea of a single tunnel in the 22-25 ish range would be a good boat for our waters. (Lake St. Clair, St Clair/Detroit Rivers)
Hi all. I picked up one of the earliest 2.0 175 Merc V6 powerheads. Choke flap carbs, before oil injection. It's serial # 4303839. It's supposed to be
Last Post By: skialot2 Yesterday, 09:13 PMHi all, first post here. Just picked up an open bow Baker mod vp hull with a 2.4 Bridgeport EFI motor that was mounted on the boat but not finished being
Last Post By: mxr181 Yesterday, 07:56 PMhttps://youtu.be/iSJaNPQWBaM?si=NTYx3QnXIRwLO9N7
Last Post By: David - WI Yesterday, 07:54 PMThe Pair has 7 years of Warranty and only 50 HRS
All others have various warranty and the ability to add to them
Pairs and Triple sets
Looking for a Brucato mounting plate.
This plate mounts to the after market side mount for a PM
WTB a Merc One Piece Exhaust Plate. Must be unaltered and No Salt Water.
Thanks
OMC head bolt thread repair
Thread Starter: lbhsbzI have what I believe to be a 87ish 200XP. New to me engine that was sitting a while. I pulled a head to check the cylinders out and going back on
Last Post By: AlliStan Today, 05:37 AM