Got this prop with an Allison xb03 with a 200xs. Had no reasonable chance to turn it so it was only ran a couple times. Paperwork says "need to turn
Last Post By: rock Today, 03:01 PMLooking for project only! Like title says. I'm in Massachusetts. 774-503-0446
Last Post By: mercnfly Today, 02:39 PMSo this has been discussed some on the facebook page but I'm getting so many different opinions i thought id bring it up here for more opinions and info
Last Post By: XXX Notch Today, 02:29 PMIf you want your looper to run, here yah go.
Never seen these for sale before.
These were ported and flowed by me.
By Lars Strom
Starting with: Paris 6 hours 1973..OMC V6 victory over Team Mercury.
Anyone with hands on experience care to share or at least discuss nitrous tuning for two strokes on here?
There’s lots of discussion and
I laugh every time I see this.
https://www.ebay.com/itm/296874322746
Or email BQUICKS2@yahoo.com
I have a complete set of Mercury Verado manuals from the 90s-2000s I think. I have to look to make sure. If anyone can use these I will find out the
Last Post By: ChrisCarsonMarine Today, 10:35 AMhttps://youtu.be/4Olk5AU_tfg?t=296
Last Post By: doug7488 Today, 07:30 AMWhat do most 2.5 260 motors draw in amps at various RPMs. Always wondered about this.
Best wishes, Carter Powell
Got to wondering about fuel delivery and what the max hp the stock laser pump can support?
Last Post By: LakeFever Yesterday, 04:44 PMI have heard mention many times there is a weight savings between the two but never saw a definitive answer. I have a black 40amp flywheel part number
Last Post By: VkingMike Yesterday, 11:41 AM
2.4 bleed lines
Thread Starter: KIRCHNERi have a bleed line,starts at the botom left goes up thru 3 Ts goes across the top, goes down thu 3 Ts terminating at the bottom intake[nipple] on top,line
Last Post By: skialot2 Today, 04:30 PM