This motor looks almost like new. It also starts cold and runs great, but then after is has warmed up a while it starts to lose power and stalls out.
Last Post By: rock Today, 06:46 AMI was wondering if someone could help me. I have a1996 Mercury 200 EFI with a Bob’s low water pick up on a small diameter ( smaller than the factory lower)
Last Post By: STELLIX Today, 06:21 AMHi,
Engine starts sometimes with all cylinders but when you start taking it to the plane it drops one cylinder off and it stays like that.
I have a complete 2:1 LH sportmaster gear set with small prop shaft and carrier.
$1350 shipped in US for what you see in the picture.
I have 5- 2.5 7 petal EFI intake plates. They are in primer.........$245 each Shipped in US
Tony
516 807-1456
Steering Question
Thread Starter: Mr BlottoI'm in Christchurch, New Zealand and have recently bought an Aussie Tennessee ski/race hull, which is derived from a 70's Allison. The boat needs a bit
Last Post By: rock Today, 06:56 AM