apparently the season is not over

I just saw a big offshore outboard cat go by. I heard it and looked out the window to watch. It's 37F and windy - whitecaps with 2-3 foot chop. Cloudy

Today, 09:47 AM

Nice set used Wizard Racing forged piston

Nice set of USED light weight Wizard forged Racing pistons with new wrist pins . On scale of 1-10 10 being new these are an 8 IMO ….$350.00 plus

Today, 09:39 AM

Camp Mack River Run Christmas Party - December 7-8-9.

Today, 09:17 AM

Camp Mack - who's going?

I'll be there from Thursday afternoon until Sunday morning. I'll be shooting photos and videos, and running two live streams during the entire event.

Today, 09:13 AM

Looking for 300xs

In market for 300xs 20" with sporty. No junk or high hour engines. Located in NJ but will travel for right deal.

Today, 09:05 AM

Post your Favorite Memes Here

I laugh every time I see this.

Today, 08:54 AM

26p choppers

26 bullet cut chopper and a 26p Allison cut chopper. Would like to trade for a nice 27 trophy. Or would sell both for 500.00+shipping and pay pal fees.

Today, 08:49 AM

26 trophy

26 trophy that won't work on my set up.(too many rpms) took it to Billy Eaves and had the vent holes enlarged and cleaned up. Has not been ran since work

Today, 08:48 AM

28 bravo1 XS

i have a 28 bravo1 XS that i would like to trade for a 27 ProMax.my prop is 9 out of 10 on ten scale. Yours has to be the same condition as mine. Bone

Today, 08:47 AM

1983 vector

Got the boat in July of 2021 and started gutting to rebuild. Built a jig to set it on and started cutting out transom, old core, stringer box and foam

Today, 08:33 AM

2 Hole CLE for sale

I have a 2 hole CLE RH 20 inch shaft lower unit for sale. Came as a extra with a boat I bought so I’m not sure if the condition or really what it’s worth,

Yesterday, 11:40 PM

1989 Mariner 175Ski

Picking up a 1989 Mariner 175Ski. Engine looks pretty clean. Appears to be a 2.4L XRI system engine.

Owner says he's been running for years

Yesterday, 08:31 PM

28p x 14"-or-less for Inline Merc

Looking to try a small cleaver on a Mercury inline project. Must be 14 inches in diameter or slightly less, 3 blades, 15 spline, small shaft, RH rotation,

Yesterday, 08:24 PM

Facts about Evinrude/Johnson racing outboards made my OMC

By Lars Strom

Starting with: Paris 6 hours 1973..OMC V6 victory over Team Mercury.

Yesterday, 07:52 PM

Ignition Coil Costs

Coil part #300-8M0077471 from Mercury is $188 and the same coil from DB Electrical is $45.
My question is should I bite the bullet and buy the Merc

Yesterday, 07:02 PM