PDA

View Full Version : 99 300 Promax buzzer



quicktrip
06-26-2005, 07:37 PM
What sensors are hooked to the buzzer? Everytime I hit 70mph she sounds and the motor cuts out. And even sometimes at slow speeds 40mph after the 70mph problem. The buzzer sounds once and the motor cuts so I let out the throttle and it stops. If I stay in the throttle it will keep sounding and cutting out. Help?????

quicktrip
06-27-2005, 07:56 PM
Anyone?

Euroski
06-28-2005, 05:27 AM
I checked my manual and the buzzer can go off for, running too hot, one of the sensors are going wacky. I don't know that much but the manual does say it will reduce RPM for some issues. Maybe you can get someone to scan the ECU's

Trikki1010
06-28-2005, 05:30 AM
Excessive RPM ???

Lack of water pressure/Overheating ??? = protection mode

quicktrip
06-28-2005, 08:58 PM
It only does it for a split second while the buzzer sounds.

mjwalters
06-28-2005, 09:12 PM
I think there is no warning sensor that shuts the motor off. Maybe you have a fuel problem

rsess
06-29-2005, 06:11 AM
Probably over rev alarm and motor going in to guardian mode. Motor does not shut off, just reduces revs. Smartcraft guage would let you know immediately.

quicktrip
07-01-2005, 07:03 PM
Anyone??

godspeed
07-01-2005, 08:32 PM
check your motor height and what is your water pressure reading if you run engine with out sufficiant water psi the engine protects it self by shutting down any other old engine will just seize up :eek: