PDA

View Full Version : XR2001 gearcase ?



Jeff "Yammer"
06-26-2005, 02:43 PM
I am looking at an Allison XR2001 with a 15" mid and a brand new 4 hole CLE on it for a case. Is this gonna be OK or can it be moddified ( cone , skeg ... etc )
Don't know too much on A-boat set-up.

Thanks , Jeff

David
06-26-2005, 02:51 PM
I have read here of people making the CLE work, but the 'red book' by Jim Barnes suggests not using the CLE w/o nosecone on Allys.

It probably comes down or up to engine height. Perhaps the CLEs must run lower on Allisons than on other boats or other lower units on the Allisons.

Single or tandem seats?

Ray Neudecker
06-26-2005, 03:10 PM
Without a nose cone CLE's don't work well on an A.

david laser86
06-26-2005, 06:10 PM
Sportmasters work fine.

Fl Boy in ILL
06-26-2005, 06:15 PM
I ran a Spormaster on my XR2001 for a very short while!! The boat had some handling problems at above 9000 RPMs, I changed to a coned torque master and it handles fine. I agree with Ray a CLE on a XR2001 isn't going to work.

Rick

TNT
06-28-2005, 12:35 PM
Bruce "Bushwacker" Bush runs a 15 inch sportmaster on his xr2001