new 115, 130, 150,& 200 ETEC for 2006

[blkmtrfan]

http://www.barnaclebillsmarinesupply.com/aboutus.html

[150aintenuff]

looks like they kept the 60* block designe for the smaller engines.. makes it nice for looking at on narrower hulls.. cant wait till they hut out here...

[blkmtrfan]

Yea the 60° 200HP looks like it might be a great starting point for lighter performance boats

[150aintenuff]

have they fullfilled theire availability yet??? and are they now available for repower or are they still not sending them....

[TAXXIVADER]

yep we are still waiting availabillity for the etec models 115 hp & above...& i,ll tell ya once they get here they will sell like hot cakes.!!


been fitting a lot of 60 & 50 , 90 etecs to fissin boats and the customers have been extremely happy with the performance & fuel economy thus far...

a lot of interest has been created by ski boat & larger fissin boat owners about the 150 HO - 200 HO models and i fear the supply wont meet the demand........

i was always very patial to mercs & yammys but i rekon BRP has done a great job with all the new models & having done a lot of on water testing with etecs i have been very impressed......cheers taxxivader...............;)

[150aintenuff]

scott did you see the 150 at the seattle show... good lookin motor,very clean easily accesible maintaince items.. cant wait to see a 200

[blkmtrfan]

scott did you see the 150 at the seattle show... good lookin motor,very clean easily accesible maintaince items.. cant wait to see a 200

I guess I missed it :o

Where were they :confused:

[JW]

I couldn't find reference to a 25" shaft motor in the 150 - 200 hp range....................wonder if that's in the works?

[msm]

JW, according to the 2006 e-tec brochure, all except the 150 H.O. can be had with a 25 inch shaft.

Also of interest is that, according to the brochure, the 2.6 litre engines weigh a whopping 90 pounds less than the 3.3 litres (419 vs 509 lbs comparing the 200's).

[Jimbo]

If BRP could build a " Sport " 200 HP 419LB motor with hard mounts , low water pickup gear case and a 6500RPM rev limiter they just could sell a few to Bullet and Allison owners.

[150aintenuff]

I guess I missed it :o

Where were they :confused:


right as you entered the event center from the stadium midway.. it was on a 21 Arima hard top..

I have pics on my camera. if I remember i will load a whole section..

[blkmtrfan]

right as you entered the event center from the stadium midway.. it was on a 21 Arima hard top..

I have pics on my camera. if I remember i will load a whole section..

Well, I came in the back way by the parking garage :o

Yes upload your pics :)

[DarthVMAX]

That would LOVE to run a new 2.6L 200 ETEC on my XB2002 Comp Pro. I just don't have enough $$$ :( (since I insist on paying cash for my new OB)

A new VMAX is in my future though:cool: