mercrazy
04-16-2001, 01:32 PM
just took the powerhead off 2.4 bridgeport efi. the exhaust holes in the plate were a lot smaller than the block. they appeared to be the same size as a stock 200 plate. this motor has the 1 piece plate and open snout housing.
1) are the plate holes supposed to be smaller or is it from some other motor? can i open up the plate with a die grinder to match the block and will it help the power to do so? is there sufficient metal there without breaking into the water passages?
2) can i open up a stock 200, 2 piece plate and get as much power as the 1 piece plate? what are the limiting factors?
1) are the plate holes supposed to be smaller or is it from some other motor? can i open up the plate with a die grinder to match the block and will it help the power to do so? is there sufficient metal there without breaking into the water passages?
2) can i open up a stock 200, 2 piece plate and get as much power as the 1 piece plate? what are the limiting factors?