Stering safety yokes.

[Redbullet]

I have some in stainless for the standard yoke.
I have a pattern for the 3 hole and offshore.
Can make them in stainless or alum T6.
If there is any interest for some quanity I'll build them. I do metal fabrication work and have and industrial laser and can build about anything if there is some quanity.
E-mail Bullet20cc@aol.com
http://memimage.cardomain.net/member_img_a/379019_66_full.jpg

[mendo]

I am interested, how much?


standard with one piece adaptor.

[Redbullet]

Standard is $65 to your door.
bullet20cc@aol.com

[mendo]

Paypal?

[Tango]

Someone send me the bolt dimensions. Redbullet can make the plates and I can get very nice Mil-Spec High shear bolts that we use on the Apache and Blackhawk Helicopters. In some sizes I can even get these in titanium. Most all bolts are fully machined, close tolerance and have some type of cad or ceramic coatings.

It would piss you off to know how much of our tax dollars are wasted to pay for these. Get me the dimensions and I'll give you a few of those dollars back!! My jackplate and 2.4BP EFI will be held on with over $10K in Titanium fasteners!! LOL! During each phase or Reset inspection, these are all thrown away and replaced.

When OUTCAST came up here to get those Crossflows, I gave him a few samples.

[Redbullet]

It's a 3/8 bolt with 24 threads per inch. Needs to be and inch long or 1 1/4".

[Tango]

Okay... That is easy. What kind of nut do you want? I have high speed balanced with integral bearing washer and a high temp nyloc insert or just standard nylocs, or castelated crown to be used with a cross-drilled shear bolt. I can also get "Jap-Nuts" which are low profile 12-point nuts. PM me with your address and I will send you an assortment. Just let me know which ones you need.

[DonChicho]

INTERESTED IN ONE FOR : YAMMY V6,1989,200 H.P.
AND OMC V4,LOOPER, 1988 .

LET ME KNOW.

THANKS,
DON

[Scream And Fly]

Mike Ray's products are top quality - you won't be dissapointed. Now if this mess with hurricanes can ever end, I might be able to get my boat out to test his drag foil!

For those of you with the smaller steering arm, you should seriously consider this item. It's cheap insurance against disaster - and I've seen what happens when a steering arm breaks. It's nothing to take lightly.

Greg

[Jay2002]

we have the nasty part of the storm easing our way now. The eye is supposed to be going below us, but the bad stuff is coming across the top of the eye. I hope and pray eveyone is safe. This is NO FUN! Jay.

[Redbullet]

I have stainless lock nuts for that thread.

Mike

[Tango]

Mike, I dug out a few of the bolts in the Garage but will get some from work on Tuesday. You will love these!

I have already had a few requests PM'd so I will get those out.

[Redbullet]

Thanks. Mike

[redFish]

Redbullet, Do you make the steering safety yoke for the 300X?
redFish

[Redbullet]

Dont know. I dont have one in the area to check it by. Not sure of the exhaust divider if it has the ears on each side to mount it.