Transom Top Plates

[Fibertron]

I was thinking of making a Top plate for my transom like the ones hydrostream sells as my second cnc project for school. I was wondering if someone might be able to give me some dimensions to get started on this.

Thanks

Bryan

[Fibertron]

SOMEONE????

I was gonna make it say hydrostream for my new hydrostream. What I was wondering was the length, thickness, width and distance between bolt holes. Someone please help

Thanks

Bryan

[Burke Kilgour]

Here ya go...........

[Fibertron]

Thanks. for the drawing, just what i was looking for

I have one more question, is the big one for the top and the small one for the bottom bolts, and can i use stainless steel instead
thanks again

Bryan

[Burke Kilgour]

Ya, the big one goes across the top and the smaller goes across the bottom. As far as bolts go, I know the ones that Mercury sells are stainless, but I don't know the grade..........
Remember to put liberal amounts of anti-sieze on stainless hardware when putting them together too.

[rmh77]

Are you looking for a transome top plate like this one?

[natzx7]

i like the bungee set up....gives it that "offshore racer" look

[Rickracer]

Stainless would work, but is not necessary. You are adding strength to wood and fiberglass, not holding a bridge together, LOL. :cool:

[race#115]

that is a sweet wooden jackplate on that !i like the seats as well :p

[Jimbob]

And check out the trim tabs!:D

[Fibertron]

Thanks for all the help, if any of you want one, im sure I can cut a few, as long as the materials are supplied. Thats boat in the pic is sweet, i hope mines like that when im done....!!