Bill Gohr - got any thrust washers?

[Stoker100]

Bill,
I have mahle pistons and top guided rods. My clearance on the pistons measures at 1.0605 according to my trusty cheapo digital caliper. The rod end is .8105, so I guess that means I need thrust washers around .125 each (.25 total).

Does that sound about right? Obviously need twelve. Do you have some you could sell me? How much including shipping? You take paypal?

On another note, I had to shorten my wrist pins in a hurry last summer. Got longer ones than would fit in the piston (couldn't get clips in. Shortened them to fit. I need to go back now and true them all up to length and weight. Is there a length range that is where they should be?

Thx!
larry

[Bill Gohr]

which rods and which pistons do you have? I should have whatever parts you need. If you shortened your pins I'mm assuming you have Mahles. I have some original Mahle pins if thats what you need. Why don't tyou just give me a call and we'll just figure out what you need. 847-356-3245

[Bill Gohr]

and measured parts, you have Mahles with big rods you need the stock early washers and pins. Give me a call.

[Stoker100]

Your awesome!!!
I will keep you posted