mikevr007
10-05-2003, 08:46 PM
I've searched for a similar post....didn't find one.
I was disassembling my trailer tongue to put on a new coupler and jack. The old coupler was bent a little... After removing everything, I noticed the tongue tube is bent. It's off by about 3/8" at the coupler, or about 1/4" at the end of the 3x3 tube. Does anyone know if this is going to be a problem? Should I put a new tongue tube on?
I was disassembling my trailer tongue to put on a new coupler and jack. The old coupler was bent a little... After removing everything, I noticed the tongue tube is bent. It's off by about 3/8" at the coupler, or about 1/4" at the end of the 3x3 tube. Does anyone know if this is going to be a problem? Should I put a new tongue tube on?