Brucato, 225 PM stuff, cranks, Hydrostream Varmint

[nitro_rat]

I’m getting out of the go-fast stuff, everything MUST go together!

1981 Hydrostream Varmint with clear TX title
several cranks, mostly 9 ring
several small bearing 260 top caps
several blocks, mostly 2.0, at least one 2.5
several fat tillers for the single ram clamp
some lower units, none coned or hi-po
brucato acu for 225 pm never used
200 pm ecu
lots of good lightly used 2.5 forged pistons (260 stuff)
lots of rods
gaskets
2 full sets of lazer injection
lots of carbs and jets
a few clamps, probably a few TX titles for motors
most of my props were stolen, you can have what’s left. Probably nothing fancy.

Bring a truck, load it up, hook onto the boat, take it all.

$3000, don’t low ball me, I know what I’ve got…

[Asstracker]

sounds like a great deal

[nitro_rat]

sounds like a great deal

You bet, deal of the year!

There’s a full sea star pro hydraulic steering system, several 9/16 amp flywheels and at least one red 40 amp flexplate flywheel, at least one 225/260 exhaust divider, piles of electronics…

[Allisbass2]

Hi, NY



Hi, any chance you still have brucato acu.

[Allisbass2]

Sorry for typo

[Merc 2.5]

You bet, deal of the year!

There’s a full sea star pro hydraulic steering system, several 9/16 amp flywheels and at least one red 40 amp flexplate flywheel, at least one 225/260 exhaust divider, piles of electronics…

Are you getting out of it josh?

[nitro_rat]

Are you getting out of it josh?
I’ve really been out of it for several years. I picked up a 15’ aluminum job with a console, tall transom, and splash well. I built a hot 25 Evinrude an ran that for a few years. A couple years ago I picked up a low hours 3 cylinder Yamaha 40hp. I don’t work on it anymore. Just take it to the river when I want to. 12 gallons of gas and a couple quarts of oil lasts me all summer instead of an afternoon. I still have my Hydrostream under the shed with no powerhead on it. I doubt I’ll ever do anything with it…