View Full Version : WTB WH 22 or 46 carbs
Kdybalski
02-13-2024, 03:32 PM
Anyone have a clean and unmolested set of wh 22’s or 46’s. Trying to run on modified 2.5/200. In need linkage and cam. I hear that Wh 20 is the big Venturi carb but not sure if anyone has had success running them.
rjdubiel
02-14-2024, 04:39 PM
I did not notice any difference from WH20 to WH31 to WH46 carbs on my 2.5 245. I do not have telematics, just seat of the pants I could not tell. I did not notice much difference from a crossdrilled intake VS standard non drilled either. Start with 84 or 86 mains and work you way down. if you get down lower than 84 mains make sure to keep an eye on your midrange, it will run lean just cruising around at half throttle.
Kdybalski
02-14-2024, 04:56 PM
Which ones are you running currently, wh46? Your jetting for your 245 correct. Thanks for the reply. Trying to get mine dialed in and hope I can find a decent set!
cdubya
02-14-2024, 08:36 PM
529770529771529772
Kdybalski
02-15-2024, 08:07 AM
Sent a pm
rjdubiel
02-15-2024, 08:55 AM
Which ones are you running currently, wh46? Your jetting for your 245 correct. Thanks for the reply. Trying to get mine dialed in and hope I can find a decent set!
Ended up going EFI.
cdubya
02-15-2024, 09:07 PM
Here ya go.
Kdybalski
02-16-2024, 06:15 AM
Sent pm. Will reach out to you later today. Will the linkage from the Wh series work on my newer series intake. Not sure how the throttle cams compare..
rjdubiel
02-16-2024, 10:37 AM
you will need the cam off that 2.4 intake and the cam rod from a 2.4 throttle are to the cam, or make one out of some round stock and thread the ends. But the stud for the cam is in the same spot.
cdubya
02-16-2024, 11:38 AM
The correct linkage and cam come with it.
Powered by vBulletin® Version 4.2.3 Copyright © 2025 vBulletin Solutions, Inc. All rights reserved.