Wnted T P I for merc v6 with laser e f i

[KIRCHNER]

merc or mariner 1988 & up 3 wire

[25two.stroke]

You lookin for new or used? Damn merc wants $823 for a new one!
I don't have any new but I have a few used.
Chris Carson has some way to make them I think from conventional circuitry stuff, but I don't know how time consuming it is.
I assume you are talking about p/n 14851T03

[KIRCHNER]

YES, the bone yard by me told me, call chris. i called hes looking for me. they were 29$ was told they are NLA. Used would work. l.i.n.y is searching too. today i checker t.d.c., idle timing @8 wot@22 ohm stator, trigger good. t p i wont go below 5v, good spark all 6. its pig rich. i cant find pt#, but its flat round plastic with two ears, slotted for screws allow about 15 deg adj each direction 3wire tan blue orange pigtail motor#OB211001 MARINER 220

[25two.stroke]

511511511512
I got 2 in front of me

[KIRCHNER]

Yepper, you got the right one. whats it worth?

[25two.stroke]

No idea. Not as much to me as it is to you. I never build lazer injected motors, so its not too valuable to me...and yours is broke so its valuable to you...

Call or text me with an offer and I'll send you one via usps flatrate tomorrow if you would like. Ask someone else what they are worth if you want, or if you find one local thats even easier for you.

[KIRCHNER]

I SENT you a pm. rather than wait for call backs, a bird in hand is better than, well you know. text me 727 two four3 41 8 zero

[ChrisCarsonMarine]

I'm pretty much out of them,so get one from 2.5,Chris

[25two.stroke]

I mailed it out to you today and texted you the tracking number.

I also threw in a piece of a haness that plugs in there, not sure if you can use it for anything but I know I never will. If you took the bad tpi you have and the piece I gave you and solder wires between them then you could make the mercury test harness that is nla. The harness is way easier to use than sliding stripped wires in the pins.

[KIRCHNER]

Thats for sure. you think 8 after is too retarded? my motor has factory hemi-heads.

[25two.stroke]

8 after is not always too low. But it is on my bridgeport. That motor likes 4. Some like tdc. I have also had stock 150 2.0L motors idle and accelerate good at 14 btdc. Every motor is different.

[KIRCHNER]

I just got the tpi. tomorrow ill hook her up.

[25two.stroke]

That was quick

[KIRCHNER]

That was quick
i sent you a pm. happy camper!