1979 Merc 200 ?

[goldwing87]

Found this motor ..old man has it on a ranger says it runs good wants 1500.00 boat and motor...Ran in 2021

My plan is to put motor on Hydrostram Viper

Is this a chrome bore? And is price to mucH?

502057


502058

[goldwing87]

And is the 1979 200 a 2.4?

[goldwing87]

I need jackplate solid mounts and dual steering set up

[rock]

There's a survivor. Should be chrome and price is up to the buyer as far as too much or too little. Make sure the Stream is sound before you apply the new power. Very nice set-up when right.

Rock

[rjdubiel]

remember you will have to drill the jack plate as this is not a BIA bolt pattern on the clamp.

[goldwing87]

remember you will have to drill the jack plate as this is not a BIA bolt pattern on the clamp.

Can u tell from this pic

502067

[rjdubiel]

That looks like the BIA bolt pattern, not the old twin ram clamp that you have. But again, you can make it work. Bolt a jackplate to the boat, drill the jack plate for the motor clamp holes. I think it is the top holes on the clamp are not as wide as the BIA, bottom hole may fit if I remember. you will have to get creative on the trim lines also as I think the old 200 you are looking at uses the hollow lower mount bolts for the clamp to pump the hydraulic fluid through to the rams.