PDA

View Full Version : My New Boat Pic


Joe Don
06-10-2003, 03:35 PM
I just Bought This one Two weeks ago........ Last night I melted a piston. Damn the Luck
Joe Don
06-10-2003, 03:53 PM
I didnt mean to post twice
Barefoot Bob
06-10-2003, 04:52 PM
But what a sweet lookin boat;)
bulldogdaddy
06-10-2003, 06:05 PM
post some more pics of that ride! sweeeeeeeeeeet:p
Scott
06-10-2003, 07:04 PM
One pic of the back? More More! Liberator? Eliminator? Most probably know but I'm a novice.

Sweet Rig!
WILDMAN
06-10-2003, 07:31 PM
Looks good Joe. Time for twins!
175checkmate
06-10-2003, 09:01 PM
Sorry about the piston. And yes more pictures of the boat are need. SWEET ride.
skydog
06-10-2003, 10:42 PM
Sweet boat!!! Did you find out why she took one out to lunch?
Skydog
skydog
06-10-2003, 10:43 PM
I could be way wrong here but would that hull like a 3 blade clever a lot better?
Skydog:confused:
Barefoot Bob
06-10-2003, 11:14 PM
I was thinkin that prop would look real nice on my Baja;)
Forkin' Crazy
06-10-2003, 11:25 PM
Nice pic.....like the others, how 'bout one from the side?

If you get a white motor you might not have those piston problems...LOL!:D
Daytona19
06-11-2003, 12:31 AM
since its junk & all, I'll give ya 50.00 for it !!! LOL
Joe Don
06-11-2003, 11:33 AM
I'll Post more pics as soon as I get her runnin again, should be within a week ! The best I can get is about 85 mph, I would like to see at least 90 any suggestions ? How about Jack plate Height ? I ran a 28 chopper did about 80, The 27 mazco does 85, slow out of the hole mid range could be better, Then I ran a 25 Trophy did pretty good, I was taching 8400 rpm 86 mph.
What should I do ?
Steve Zuckerman
06-11-2003, 12:07 PM
Joe Don:
Are you that Waking Tall guy? Just kidding man. I'm sure that boat
can use a LOT of setback. I can't tell what you've got on there now from angle of the picture, but I think a 21' with a single needs at least 12" to 15"s. Chuck Goodman/Hydro Dynamics makes a very nice powdercoated unit in both sizes and can give you lots of excellent performance advice on all subjects. You can reach Chuck @ 318-965-0201.
The farther back you go, the higher (transom height) you can run,
with less positive trim, which makes for more efficient use of your
existing HP.
I ran a 4 blade RE on my bassboat (20' Bullet), and it worked very well for general use. I think a 26" or 28" Yamaha clone or Lightning ET will be better for top end in your application.
By the way, beautiful boat. I hope that motor is under warranty!
By the way Forkin', I agree with you. If he had a white motor he wouldn't have a burned piston. He'd have 3 or 4 :D!
Regards,
Steve ;)
WILDMAN
06-11-2003, 12:38 PM
Joe, give me a call about your setup. 386-761-8050