Mercury Prop Shaft Protectors Interest

[HStream1]

OK Friends. I posted pictures on my Face Book Page of the prop Shaft protector I had made. And I got contacted by several interested people. I finally found a Shop that is interested in Making them in quantity 25 Minimum. I wanted to get the price down as far as i could. If i can get enough Pre commitments (at least (12) Ill pull the trigger on the first 25. The price will be $85.00 each plus shipping which should be around $10.00. They will be for small shaft mercury lowers only to start. But if I can get enough Interest in Fat Shafts ill have them done as well. Call or PM me your interests.

487126 487127 487128 487129 487130 487131

[XstreamVking]

Those are works of art....

[HStream1]

I thought sure there would have been more interest in these?? Especially for the price and being made from 6061 T6 Aircraft Grade aluminum.

[JCSmile]

I've seen these in the past, what is the intention of these? Keep contamination off while trailering? Good looking piece

[HStream1]

Basically thats exactly what the purpose is. Keep road debris off the shaft and grease. A piece of PVC also works. But PVC wont protect is something flies up and hits the shaft at 60 plus MPH.This one is designed to actually seat on the prop washer face and Boss as well as a tight slip fit to the shaft.



I've seen these in the past, what is the intention of these? Keep contamination off while trailering? Good looking piece