Mercury top end cap

[buzmacdowell]

The part # 1159-5457....what v-6 motor does it go on?it has the smaller (more) needle bearings.

[mach351]

Pretty sure those were early 2.4

[tlwjkw]

Pretty sure those were early 2.4

hi performance.. oval and bridge ports.........

[mach351]

I had an 81 225 that had it.

[tlwjkw]

yeah, they did.. so did "some" of tha 2.0's in first gen motors... pre 2.4.. very long time ago..

[buzmacdowell]

Thanks...very much....I am just going through a lot of older parts and couldn't remember what they went to.....for now I just flip them upside down and use them for crankshaft stands....

[nitro_rat]

should work on non-oiler 2.0/2.4 and early oiler (2.4 era 2.0's). Also works with hi-po non oiler cranks but doesn't have the bearing retainer plate like a small bearing 260 cap.