Samrod
11-25-2019, 09:18 PM
Any advice on Mods for a 1995 15hp Evinrude, 2.375 "big bore".
- Already got a set of CCMS reeds.
- Is shortening a bit the tuner help / removing baffle plate in midsection?
- Drilling hole above cav plate?
- I shave the head very little, but had to file a bit the corners of pistons as it was touching the head
- I hear about a water passage near exhaust need to be block? Anyone has a pic of it
- Carb Jet; it has a 54D, is a 62d too much?
- Any specific / prefer CDI, Plugs., cables, Rings, etc..
- Any other tricks?
453447
- Already got a set of CCMS reeds.
- Is shortening a bit the tuner help / removing baffle plate in midsection?
- Drilling hole above cav plate?
- I shave the head very little, but had to file a bit the corners of pistons as it was touching the head
- I hear about a water passage near exhaust need to be block? Anyone has a pic of it
- Carb Jet; it has a 54D, is a 62d too much?
- Any specific / prefer CDI, Plugs., cables, Rings, etc..
- Any other tricks?
453447