Gorilla0178
06-07-2019, 10:48 AM
I appreciate all the help I have gotten here for my motor. I have a few more questions. The motor is running good for the most part. Had it out a couple times and runs good..... Now I haven't done too much tuning to it so far. What are the best plugs for a 3.0 looper? It had QL77JC4 in it which is what I also put in it. There is a Ocean Pro at the shop same year and power that has QL78YC, ive read some posts that recommend NGK plugs. Im running into the issue where on a fresh set of plugs itll start right up, now that ive run it a bit its a B#$%h to start. Started with new plugs on the hose twice in 2 trys. Now its iffy. Once it starts itll crank up every time. I even hook the jump box to it to make sure there is enough power. How can I check the speed of the starter? I know if its not spinning fast enough it wont make spark. I recently pulled the flywheel and cleaned the timer base, not too much goo dripping off. Only 2 drips which I cleaned off. The stator charges at 14 volts when running. I also ran into a issue when I was idling around for awhile waiting at the ramp, it stalled out a couple times, not right away but after about 10 min. I was wondering if the plugs are not right and getting fouled at slow speeds. Any info is appreciated.