activator22
01-28-2019, 11:58 AM
1990 2.4 Bridgeport carb - ran just fine, but down on power and should be re-rung/new bearings (compression was under 110 all holes)
cross drilled intake, believe they are wh-20 carbs but will verify
On 20" smoothback offshore mid with offshore clamp and single ram trim
CLE lower gear housing with std 1.87 gears, small propshaft, should be re-sealed This had a std lower and the internals were moved over to the CLE case, so I do not think the bearing carrier is the hd version.
factory lt weight merc cowling, with some cracks in the bottom where it sits in the pan (typical) Needs paint, have replacement decal set ready
Saltwater motor, but lived in driveway and always flushed after each day's run
Will get pics loaded in the next day or so
$2000 obo - pick up only - West Haven CT
cross drilled intake, believe they are wh-20 carbs but will verify
On 20" smoothback offshore mid with offshore clamp and single ram trim
CLE lower gear housing with std 1.87 gears, small propshaft, should be re-sealed This had a std lower and the internals were moved over to the CLE case, so I do not think the bearing carrier is the hd version.
factory lt weight merc cowling, with some cracks in the bottom where it sits in the pan (typical) Needs paint, have replacement decal set ready
Saltwater motor, but lived in driveway and always flushed after each day's run
Will get pics loaded in the next day or so
$2000 obo - pick up only - West Haven CT