500 lb motor on a vector?

[gdp]

Anybody hang a 500lb motor on a vector? Did it want to sink? Would you do it again? Handling bad? New high horse power motors are so heavy.

[Captaincj]

Should be fine as long as you use at least 12" of setback...

��

[XstreamVking]

IMO the heavier the engine the less setback needed. I have run 505# optis on my V-King with no issues.

[Captaincj]

Yeah, I was joking...

500lbs on a Vector is probably pretty questionable to begin with with NO setback. I don't think they handle weight as well as a Viking/V-King.

[Captaincj]

IMO the heavier the engine the less setback needed. I have run 505# optis on my V-King with no issues.

Speaking of 505#s on a V-KING, how would you like to have one of those new 300 Merc V8s on yours? It's about 500# isn't it?

You think that's a good choice or not?

[XstreamVking]

It would be interesting capt...But the V-Kings will handle anything you can bolt on it. As long as you have the nads to drive it.

[1BadAction]

Vectors handle like ass with normal weight V6s on them, I wouldn't mess with anything heavier.

[Capt.Insane-o]

I have my 15inch motor bolted right to the transom

[Captaincj]

It would be interesting capt...But the V-Kings will handle anything you can bolt on it. As long as you have the nads to drive it.

I’m certain I don’t have the nads yet. With the reported torque of that V8, it would have to be an upset-event every time you pressed the gas peddle on a little V-King!

[XstreamVking]

I would take a 300XS any day over one of those fugly things..

[Captaincj]

It's true they ain't pretty. But that torque sounds FUN!

[rkmirage]

Vectors are very sensitive to weight on the transom, stay with a 2.5 at about 375lbs.