Inline 6 3 button Trim Wiring

[tdogcarter]

Does anyone know what color wire goes with what on the older inline 6 3 button Tilt and Trim switch.
If I can remember right, there are like 4 wires.
Red, Green, Blue, Black?

And you solder them to the connectors on the old 3 button tilt and trim.

the one where you have to hit two buttons to get it to tilt out of the water?

If you do thanks for sharing. I got a new one, and it does not have any color leads on them, or a wiring diagram.

Thanks

Trey Carter

[10.5' Tunnel]

Diagram off how mine is wired. As you can tell i suck at drawing:)

[ShorePounder]

Bear with me until I can get home and I'll scan the diagram out of the book and post it for you. Check back around 8:00 PM or so. Unless somebody beats me to it.

[Superdave]

Should be a purple one. That's the "limit" wire.
Dave

[ShorePounder]

Here's one

[ShorePounder]

and another

[tdogcarter]

Superdave.

yes, there is a purple wire, I was going by memory. DId not have the trim pump and wiring harness in front of me.

Thanks guys for the diagrams

Trey