bigboy
07-20-2017, 02:56 PM
Hi all,
I have an adapter from a BP that has large exhaust holes to match 2.5 exhaust. I havent measured them. Can do on request.
The plate has some corrosion at the mating surface. One spot next to the exhaust opening need to be filled / welded.
Best would be to have it shaved / milled down to make it into perfect condition. (I did this myself with another one before. Sanding with belt sander and finish on a big sandpaper clamped on a straight surface)
I took all the corroded studs out for the tuner so it's ready for your tuner and bolts. I forgot to take the broken bolt out for the water tube grommet.
250 shipped to lower 48 states.
I have an adapter from a BP that has large exhaust holes to match 2.5 exhaust. I havent measured them. Can do on request.
The plate has some corrosion at the mating surface. One spot next to the exhaust opening need to be filled / welded.
Best would be to have it shaved / milled down to make it into perfect condition. (I did this myself with another one before. Sanding with belt sander and finish on a big sandpaper clamped on a straight surface)
I took all the corroded studs out for the tuner so it's ready for your tuner and bolts. I forgot to take the broken bolt out for the water tube grommet.
250 shipped to lower 48 states.