Mariner 225 Supr Mag SS trim sender wire

[stv1991]

Plugged in a brand new wire harness on my motor. Brown/white wire should be the trim sender wire but I see nowhere to plug it in under the cowl. The SS has the remote trim pump in the boat. Could it be on the pump somewhere or what am I missing?

I saw no brown/white wire that matches under cowl and some wire diagrams I've seen says the brown/white matches up with a straight brown wire but I don't see that either.

Any ideas? Motor is factory stock.

[90 5.0]

Trim sender??

for a trim gauge?? SS mids have no trim sender, have to run mechanical gauge

[Go Time]

Should plug into the brown/white lead at the boat wiring harness just below the 8 pin connector. I was not aware they still made a trim sender for the single ram mids.

[stv1991]

There is nothing to plug into. I've looked multiple times, there is nothing that I can see. The previous post is probably the answer?

[Go Time]

The boat side of the harness normally has 4 wires that come out from the base of the 8 pin cannon plug. If not, then you may have a seperate trim harness to the trim pump in the boat that includes the brown white lead. If you don t have that either, then you will have to run your own signal lead to the center post of the trim gauge

[CNC_Guy]

My shorty has no sender, is stock as far as I can tell. i used a Stainless Marine. It is a special 1 for the shorty.

[tlwjkw]

Trim sender??

for a trim gauge?? SS mids have no trim sender, have to run mechanical gauge

pretty much says it all!!!

[Go Time]

Early model single ram swivel brackets had trim senders...if his shorty used an early one that was cut, it can be fitted w/ a sender. I think you can adapt a sender to a late model swivel bracket provided you have the slot in the upper ram pin.

[tlwjkw]

your just talkin' ta hear yourself rattle... none of that junk was mentioned anywhere...........

[Go Time]

Yeah......just stirrin the pot.
Its 100% correct that a factory ss will not have a trim sender. I assumed he had one installed and was looking for propper hookup. ...ASSUME....NOT

[tux974]

Trouble maker...;) You will have us guys looking for something that does not exist....:eek:..:D