PDA

View Full Version : 15" Mercury Drag Mid-Section



harmon431
02-01-2015, 02:57 PM
just sold my allison.......so this nice 15" needs a new home.

factory Merc 15" drag mid ( short ram )
clamp lightened by galen burden ( steering arm still on mid for hyd. steering setup) -- very rare
boatworks exhaust tuner w/ JSRE drystack
exhaust relief slots
45 degree drag snout..

this is a factory mid.........not a cut down one...........short trim ram..........

comes with stainless trim lines and mercury trim pump........ready to install and race.

price $4490 firm........plus the ride

serious callers only 205-965-8638
no trades
no texts
call....314047314048

jas638
02-01-2015, 03:08 PM
3grand in hand

harmon431
02-03-2015, 04:40 PM
this is a factory DRAG short ram mid.........lightened by galen burden........steering stem will work on hyd. steering..... look at everything again and this is a deal..........dont believe you can find one less.....

motorheadbishop
02-03-2015, 06:19 PM
this is a factory DRAG short ram mid.........lightened by galen burden........steering stem will work on hyd. steering..... look at everything again and this is a deal..........dont believe you can find one less.....

How much lighter is it over a stock 15" ?

Chummy
02-04-2015, 07:26 AM
How much lighter is it over a stock 15" ?

23.5 lbs lighter than a 15" with the long ram setup.

12lbs were lost on the swivel, 2 lbs on the transom brackets, and 9.5 lbs by swapping from a long ram to a short ram.

24ss
02-18-2015, 11:29 PM
:cheers:

Greg G
02-18-2015, 11:38 PM
23.5 lbs lighter than a 15" with the long ram setup.

12lbs were lost on the swivel, 2 lbs on the transom brackets, and 9.5 lbs by swapping from a long ram to a short ram.

That's pretty impressive. Is it true that a ROS mid and clamp is about 55lbs heavier than a bass?

24ss
02-18-2015, 11:38 PM
Sweet :cheers:

patchesII
02-19-2015, 06:11 AM
That's pretty impressive. Is it true that a ROS mid and clamp is about 55lbs heavier than a bass?

The ROS is heavier but I doubt very seriously it's 55 lbs

dbug10
02-22-2015, 01:08 AM
Mike I am going to look at a 15 mid that has been lightened next week I might be able to hook you up it was all done on a mill and I have a Bridgeport Mill and even know how to use it a little lmao

Mtwhitt
08-14-2018, 11:02 PM
Is it still available?