wuhbbr
06-10-2014, 09:33 AM
I'm looking for a 4" power jack plate, for a 15' Critchfield with a 1970's, 1500XS I'm riggin'.
Seems the problem is, that old motor did not use todays BIA bolt pattern, plus the trim cylinders are mounted on the side of the engine, making it too wide for the modern jack plates.
Any body know of a jack plate that'll work or I can make work? Ideas? Thoughts?
Thanks, Ray
Seems the problem is, that old motor did not use todays BIA bolt pattern, plus the trim cylinders are mounted on the side of the engine, making it too wide for the modern jack plates.
Any body know of a jack plate that'll work or I can make work? Ideas? Thoughts?
Thanks, Ray