View Full Version : 1991 Bridgeport with a promax/260 powerhead and brucato PCU $6,500

04-19-2014, 08:17 AM
1991 Bridgeport offshore with cle gear case. Comes with trim pump and everything to make it run. Gearcase needs a toqure tab installed. Powerhead is fresh with about 2 hrs on it. It was bought on here from Fast120. He used a 225 promax block with a 260 front half. Said he did some mild porting. The compression is 152 lbs - 155 lbs on all cylinders. Has a Brucato PCU. It's part of a project boat that I have decided not to finish. Motor is still on boat so it can be run.
Everything for $6,500
everything minus the pcu $5500
Powerhead with PCU $5,000
Powerhead only $4,000


04-20-2014, 12:13 PM
I would be interested in the cowling if you split it all up is the powerhead all nic

04-21-2014, 06:12 AM
I would be interested in the cowling if you split it all up is the powerhead all nic

The powerhead is a steel sleeved Promax block. If I part out I'll let you know. I may keep the powerhead as a spare for my Stock 225 promax I have on my runabout.

05-04-2014, 01:31 PM
Any details on whats inside the powerhead? Pistons, rods, bearings?

That's Right
05-04-2014, 02:57 PM
This is a very confusing ad, I can't follow what you have.

05-04-2014, 05:01 PM
Release the mfn dragon!!!

That's Right
05-04-2014, 05:14 PM
release the mfn dragon!!!


05-04-2014, 06:19 PM
I may be in for the mid/clamp and trim pump if you split.

07-01-2014, 12:33 PM
Interested. Check your PMs.

07-03-2014, 09:28 PM
Sounds to me like it is a 2.4 offshore, ridgeback mid, cle lower, steel sleeve 225 ProMax block with horn front half.