Need help Finding the correct thrust washer

[life is good]

I have a sportmaster and I am running a mazco RE prop. This set up is new to me but it seems that I have the wrong trust washer. When installed the back side of the thrush washer contacts the carrier right around the props shaft seal. It seems like I need a different washer with a different amount of taper so that it doesn't slide as far onto the prop shaft. Has anyone else run into this before? Are there different thrust washers or are they all the same? Any suggestions would be appreciated.

Thanks in advance!

[transomstand]

If it's a fat shaft, it doesn't use a thrust washer, there's no taper in the propshaft for the washer to seat against.

[life is good]

It's a standard shaft. It definitely has a taper in the shaft

[transomstand]

What prop are you using?

[life is good]

A mazco re 30

[Jamescole]

i have ran into some issues with the Brass prop washers spin on the shaft and wear the hole bigger. what Case were you using Before? and any way of posing a pick of the washer ?

[transomstand]

Don't recall if that uses a stepped washer, but if it does you need a 13171T1

[life is good]

James you were correct. The washer was just very worn. I put a new washer on and it fit snug against the taper and everything looks good now.

thanks for the help!

[Dave Strong]

Don't recall if that uses a stepped washer, but if it does you need a 13171T1

There was a small dia. non stepped one, have a couple anyone know the #.

Dave

[transomstand]

There was a small dia. non stepped one, have a couple anyone know the #.

Dave

I've got one, but it's in the boat. Won't be able to get the number till spring.

[life is good]

I called mazco and they knew which one i needed. It does have a step on it. New one on the way.

[Dave Strong]

I've got one, but it's in the boat. Won't be able to get the number till spring.


I have one here but no number on it.

Dave