View Full Version : Cutting down a Yamaha midsection to 16"
deCler
04-15-2013, 01:24 PM
Has anyone made a short shaft mid for a Yamaha 2.6 V6 carb motor? I've been told you can't weld a Yamaha because of the material that was used to make the exhaust tower. Has anyone out there cut one down?
rev.ronnie
04-15-2013, 08:15 PM
I have welded the leading edge on the skeg on my 200 Yamaha and it was like trying to weld a graham cracker with a black licorice rope...
the material gasses out as you weld and you have a hell of a time getting an "eyeball" to roll.
Also, I'm gonna need that trim moulding at some point here. I'll measure it tonight.
deCler
04-16-2013, 07:41 AM
Reverend,
Are you saying it can't be welded?
I have the molding set aside for you. Aaron needs some too. Is it easiest for me to drop it at Xtreme, or do you want to come to Edina for a visit?
deCler
04-17-2013, 10:28 AM
Geometery doesn't work on a pre-1996 Yamaha. Going to try to build a Yamarude midsection instead.
BOB LIPTON
04-24-2013, 10:20 AM
I have a 15" mid with driveshaft ready to go if interested.
deCler
04-24-2013, 10:24 AM
Thanks for the offer.
I got it all figured out. I'm down to 15" using between the clamp bracket trim/tilt and still have full tuck under and steering range of motion. At the body shop for cosmetic work now.
DoktorC
04-24-2013, 10:38 AM
I'll be interested to see this when it's done.
I had a 14" but it was homemade
http://i54.tinypic.com/20p5jb.jpg
http://i54.tinypic.com/21ln039.jpg
BoomerMuskoka
07-21-2013, 07:33 PM
gahhhhhh!!! how did you do that Dok?
deCler
07-24-2013, 08:24 AM
279859
deCler
07-24-2013, 08:27 AM
279860
Mitchie
07-25-2013, 08:18 AM
That looks cool man....
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.