gannon311
08-21-2012, 09:16 PM
It's a 97 javelin 379se and 97 intruder 150. I'm not sure on the motor it has no tag.
I come across this forum searching for some upgrades to this motor. Man you guy sound like u really know your stuff!!! Never knew there was so much to these little jewls. Any way my question is is there any way to find out what model number I have?
Also it has been acting up! I have a service manual on the way. I will have to do all the work myself. The front of the motor is all wet looking around the carbs. What would cause this? And would this cause idleing problems?i can put it in neutral around 2000 rpm and the it will idle in gear for a min. Or so then dies and is hard to start. Anyway I'm getin long winded here. It's doing a lot of diff. Stuff and not doing right.
With a raker 26
5100 wot
52 mph(gps)
20 lbs water press.
6 inch prop to pad
With raker 24
5600-6000
55 (gps)
20lbs press
same prop to pad
Does this seem about right for this set up?
I come across this forum searching for some upgrades to this motor. Man you guy sound like u really know your stuff!!! Never knew there was so much to these little jewls. Any way my question is is there any way to find out what model number I have?
Also it has been acting up! I have a service manual on the way. I will have to do all the work myself. The front of the motor is all wet looking around the carbs. What would cause this? And would this cause idleing problems?i can put it in neutral around 2000 rpm and the it will idle in gear for a min. Or so then dies and is hard to start. Anyway I'm getin long winded here. It's doing a lot of diff. Stuff and not doing right.
With a raker 26
5100 wot
52 mph(gps)
20 lbs water press.
6 inch prop to pad
With raker 24
5600-6000
55 (gps)
20lbs press
same prop to pad
Does this seem about right for this set up?