View Full Version : 1993 Rude 120 wont run after refurbish the carbs?
Turbonito
07-07-2011, 01:07 PM
i refurbished my carbs with a Sierra kit, and have adjusted the fuel float level to be +1/32, the back end of the loater is 1/32" above the housing, but the negine only run on choke now?
itīs obvious it doesnt get fuel, but i dont get it why?
-any ideas?
perfmarine1
07-07-2011, 04:23 PM
i refurbished my carbs with a Sierra kit, and have adjusted the fuel float level to be +1/32, the back end of the loater is 1/32" above the housing, but the negine only run on choke now?
itīs obvious it doesnt get fuel, but i dont get it why?
-any ideas?
f suffix or s carb, did it have needle valve or not, if so what did you set it at.
Mark Poole ModVP
07-07-2011, 09:30 PM
I have seen problems with those carb kits. Spend the extra money and get the OMC kits.
I encountered a problem with those engines years ago.....when the airbox is put on it can kink the fuel lines going to each carb. I think the no. 3 carb hose was the worst for doing this. Double check all of your hose routing.
Powered by vBulletin® Version 4.2.3 Copyright © 2026 vBulletin Solutions, Inc. All rights reserved.