OMC Galen Burden O-Ring Heads

[95RapidRiot]

Anyone know the size O-Rings that fit these heads? I can't get a hold of Galen to find out. I have tried the White Taylor Marine PTFE .070" thick that have a 4" ID AND 4 1/4" OD. They are too small unless they can be stretched some how. I am measuring 4.115" ID and 4.250" OD with calipers on the actual head. The .070" thickness seems to be correct.

Any help greatly appreciated!

[mn808gade]

find a Parker dealer near you.(parker hydrolic/orings). they have it all.

[95RapidRiot]

No dealer near me.

I can't even find the size on the net anywhere????

[RONNIE]

mc master carr

[95RapidRiot]

That was the first place I looked. The size is not listed.

THANKS!

[mn808gade]

is this a round,quad,quad-v, style o/ring or other style??

[6Killer]

You got the right ones. Stretch the McMaster Carr ones so that they just go in the groove. They work fine.

[RRRevinrude]

yeah--what 6killer said....if you check our previous pm's roger you will see where i told you that they have to be"stretched a little to fit"....put your fingers inside the orings and gently tug -rotate the oring 90 degrees and repeat....they will fit.......................greg

[95RapidRiot]

I thought they would be a little closer in size.

THANKS GUYS!