Need help setting up laser LTV

[84laserlady]

I have an '84 17' 6'' Laser LTV Kevlar hull, It came with a '87 X-flow 150 with a nose cone that runs flawlessly. I need some help with setback, motor height, prop and any bolt-on engine mods and I'm thinking some wedges since the LTV has so much negative transome angle to begin with. Any thoughts would be helpful, I'm going to start taking it apart soon.

[200valeroyt]

a general, all around setup would be a 6 in plate, chopper style prop and prop height 1/2 - 1 in over pad. Should work ok with the 150.

[D.Ally]

i had a 85 and a 175 he had a 84 w a 200 both mercs but 6" jackplate on both but mine and his loved cleaver style 28 p bout 78gps on mine 85 on his tail liftin get the transom up and run it witha bit of positive trim and drive it should work . nosecone ? if yes then mine 1/2- 3/4 depending on fuel and people . was a blast to drive very forgiving up till 90s then they were known for blowin over !
dave

[mastertrax]

TTT:thumbsup: