View Full Version : help setting up a vector
spongebob440
01-08-2011, 10:14 PM
89 vector,150 RX2, has a 6'' jackplate,w/26 chopper , low water pick up..... where should i be on the motor height?:confused:
.....thank you ,
spongebob!
97 TWISTER
01-10-2011, 09:50 AM
I'd say even with pad to 1.5" above. You will have to play with it to the sweet spot, but a good place to start. Watch water pressure and if the boat starts to crab walk you are to high. My .02
Speed Jr.
01-10-2011, 12:27 PM
If you post your question in the PowerTour thread, you will get some great feedback from some great guys....Ive been told as a rule of thumb, start even with pad and keep going up 1/4" at a time till it gets out of hand, than back it back down an 1/8".
Jr.
transomstand
01-10-2011, 12:33 PM
Ive been told as a rule of thumb, start even with pad and keep going up 1/4" at a time till it gets out of hand, than back it back down an 1/8".
Jr.
Somebody already told him that, but he ain't listening:rolleyes:
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.