View Full Version : eagle one 18 set up
MirageBoy69
11-21-2010, 03:25 PM
I have a eagle one 600 +/- pnds and running a Merc 260 with A63 ECU, 8 " set back , 20 inch mid ( offshore ) and sportmaster case . For draging and good top end , at what height should be ok to put the engine ??? ( using a yammy 24 wheel ) ...
I will appreciate your help guys ... Thanks ... Jose
bigbluechevy454
11-21-2010, 08:47 PM
my i'd say 1.75 above the the pad i run as high as i can and keep good water pressure
MirageBoy69
11-23-2010, 06:06 PM
Thanks Bigbluechevy ....
Any more ideas ??? opinions ???
Thanks , Jose
Tague
11-28-2010, 06:18 AM
my i'd say 1.75 above the the pad i run as high as i can and keep good water pressure
the best way i found to do this is level the boat, and then level the drive so they are at the same angle. Take a straight edge on the bottom and move the jackplate up until the straight edge hits the water pickup. Don't worry about the tip of the bullet just worry about the water pickup every 1/16 can be alot. I
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.