does it take time to build rpms???

[skydog]

I have a 89 2.4 B.P. EFI(78 Vulture 10 in set back) with about two hours on it.And i am spinning a 25in Lazer prop for break in, I have not stayed in it to hard or long but with this prop should it just bang right to 7500rpms +++ Or you need to work at it alittle bit, trim, jack---and then will the rpms keep climing?I have had it out one time so please bear with me just hope it is make the power it should be?! THANKYOU SKYDOG

[Dave Estes]

Take it to the lake at night. Remove the cowlings and start it in the water. Look at the coils and see if they are arcing to ground. I did this to mine and it looked like a fireworks show. I siliconed all th plug wire caps and it stopped. Runs like a raped ape now. Sorry Fester

[DaveR]

What have you had the rpms to? With or w/o triming? At WOT or something less?

[Dave Estes]

You canleave it on th railer. If it doesn't arc at idle, put it in gear and rev to about 2000-2500rpm's. That's where the power curve picks up to planeoff

[skydog]

I have had it to about 6100-6300 rpm THANKYOU For the help guys! SKYDOG