2.5 electric problem

[sean1982]

hi, can anyone help me? i ran my 2.5 200 powerhead with the 40 amp electrics and over revved it to over 6500rpm, it seemed down on power after that so i finally got round to putting on a 16amp, it seemed to rev fine again but drops to 4000rpm struggles then seems to rev out again? took the plugs out and the bottom 4 look ok and used but the top 2 are clean as a whistle? could i have burned a coil out or switch box when the stator and rectifier melted?
cheers

[marquis4606]

carb/efi? clean as a whistle could mean water intrusion and they got steamed cleaned. that or they are not gettin fuel. ck and clean all the grounds put timing light on 1&2 and verify spark. no spark move coils around and see if problem follows. if problem follows replace coils if not then ck trigger output and switch boxes.

[sean1982]

There was alittle water on the plugs, could have bothe headcgaskets gone or exhaust manifold gasket?
Cheers

[Jay Smith]

Do a compression test that should confirm the head gasket health question.


"Be who you are and say what you feel....
Because those that matter...
don't mind...
And those that mind... don't , Won't or will EVER
matter."

Jay

[marquis4606]

change out the head/exh gaskets retest and make sure u have no more water intrusion

[sean1982]

i have new headgaskets to put in so i will do that, forgot to mention the there was a hole at the top of my airbox where the top carb is, at first i thought it wight have sucked some water in the top carb or is that not really possible?
cheers

[marquis4606]

take a fuel sample from your tanks and change your water/sep filter