Bullet XDC Lower Unit/Prop

[Bullpine03]

I have a 12 inch jack plate and may need to replace lower unit and prop set-up. I have a 225EFI on 21+Bullet XDC. What are my best options as usually fully loaded for fishing? Not drunk , just gear, gas, full livewells and one maybe two passengers! LOL

[eh350x]

hey man what size prop are u running ,what is your propshaft height in relation to the pad ,and is your lower unit stock ( I mean is it sportsmaster or something like that

[Bullpine03]

The lower unit is toast and was an after market custom with low water uptake. The prop is just ok (good hole shot but slow at top end) and shows exhaust blow from the outer rim of the hub. I have order a new SEI stock lower unit so I am down to the prop. I am going to start at 3 inches below hull , because on old set-up if I was higher then that and it caused over revving. Any ideas on the props for this set-up?

[TiGer85SS]

You need a torque master gearcase and depending on what gears you are running something like a 26-28 pitch trophy, txp, or hydromotive.