Rigging tube to Yamaha 130. Clamp for tube at engine?

[Mr. Demeanor]

I installed a TH Marine rigging tube today to clean up the transom. The motor has a 2" OD rubber grommet that the hose slips over and its snug but not tight. I would like something nicer than a hose clamp or big zip tie to snug it down. Any suggestions?

I thought this might work well.
http://www.jegs.com/p/Gates/Gates-Power-Grip-Clamps/943359/10002/-1

[XstreamVking]

Looks like a nice way to end the hose. I can't see any reason it wouldn't work...

[Mr. Demeanor]

The only problem I see with that is its pretty permanent. I think your going to end up cutting the hose if you need to remove it.

[flabum1017]

The rigging hose id pretty stiff stuff, I wonder how much force that heat shrink clamp can make. Did you try taking the grommet off and just feeding the hose through the pan?

[CmanColin]

http://www.yamaha-motor.com/outboard/accessories/acscitemdetail/5/307/1122/9147/all/1/2698/0/detail.aspx

[Mr. Demeanor]

Thats is similar to what I have now but on the engine side, the hose fits snuggly over instead of into the adapter. I may just go with an anodized radiator hose clamp. Cheap bling and will hold it in place.