A6 lean spots?

[h2oskiier30]

Where are the lean spots in A6 ecu's? Like A63's, or different? I'm about to start breaking in a "medium" ported 260, and don't want to burn her up before getting to open her up. I have an A36 and a 39lb regulator I could put on for the break-in if that would be better.

[RBT]

On pump fuel it will should be ok. They are the same (close) to the A63.

[Jay Smith]

I find the A-6 and A-63 to be a bit lean in the middle ( 5500 ish ) AS long as the compression is pump gas, the timing is no higher than 25 and your in high humidity boating area you'll be OK

Jay

[patchesII]

What is the box set on

[Jay Smith]

Only draw back with richening the whole curve too fatten up one narrow segment of a curves problem is that the complete rest of the curve is now pig fat and lazy...If you using this for pure recreational use have RBT re configure the complete cure to be more user friendly..

my .02

Jay

[patchesII]

I agree. I was just talking about for breakin. I thing the best thing to do would be to sell it to me:D:D