PDA

View Full Version : Mercury Tech New sleeves and rings


Raver
09-28-2009, 05:06 AM
Where to start on ordering new sleeves and ring for a 92' 2.5L 260? It's time for a rebuild.
patchesII
09-28-2009, 05:59 AM
only one place in my opinion to call if your re-sleeving or re-plating.

Jim Ruck
1 920 233 3833
HStream1
09-28-2009, 01:28 PM
only one place in my opinion to call if your re-sleeving or re-plating.

Jim Ruck
1 920 233 3833

:iagree::iagree: This guy will send you back a motor with bores that are within .0005 ths.
Tom Foley
09-28-2009, 01:39 PM
Power Performance Engineering is also top notch . 727-573-9288
johnnyracer
09-28-2009, 02:27 PM
Hey Dean , I dont think youll have to do new sleaves. I think a hone will do it. Have to try it and see what it looks like. Your cylinders weren,t bad out of round on the right bank and Im sure the left will be the same. That block is the old german (REAL) Nikasil. Tough stuff . I think its better than the new NiCom myself.

Have yall run it anymore. I was wondering if it was different with all the horn orifices cleaned out. We were at Highpoint yesterday breaking in 2 motors and testing Roberts with tite heads on it. Kinda expected to see yall out there.