Finger ported 200 XP

[phil blomquist]

Recently bought taylor marine finger ported motor with one bad cylinder. On tear down i found this problem see atached photo. motor was bored to 3 liter so not much room for boring also cylinder damaged is 30 thousands over the others whoever rebuilt before put std piston in hole. my question is if theres anyone in pacific northwest that can resleeve and fingerport or do i send block to tayler marine or does anyone want to buy motor,big bore carbs,racing heads:confused: thanks phil

[scc82]

CCMS can do it right, we are located in south fl. pm me for more info and prices.

[phil blomquist]

thanks for quick responce florida is pretty far to ship but waiting for pm at pjfloors@comcast.net phil

[scc82]

pm sent, dont know if email went through, was having prob.

give a call
CCMS 800-329-2725
thanks stan carson,

[phil blomquist]

stan thanks for info i will be calling you soon for info:)

[racer]

The picture shows a 2.7 bored to 3.0. The sleeve on a 2.7 goes all the way to the bottom and needs to be bored with the correct cutter to maintain a recess at the bottom where a hone will not reach. We have the sleeves and equipment to do this.

[phil blomquist]

racer. where are you located?im trying to find somebody close to wasington st. to save some shipping thanks for reply:smiletest::)

[beamrverbeek]

quality boring in everett wa. call dave at sky valley marine and he can hook u up. 360 794 4116

[baja200merk]

Send it to stoker if you want it done right, end of story...

[phil blomquist]

how about some info on stroker where located or phone number thanks:)

[phil blomquist]

thanks for number and info id like to keep it close do they resleeve and fingerport? i will call them soon sorry for slow reply internet went down thanks phil

[baja200merk]

pm racer above

[phil blomquist]

I just wanted to say thanks for all the information from this site seems whatever brakes down somebody always has a answer.Its such a great tool we can all be gratefull thanks again for all the support phil:cheers:

[Hotboat1]

Hey Phil, A little JB Weld and it will be as good as new!!!:icon_bs:

[phil blomquist]

J b weld this you sweude shoe operater i already tried it motor ran 8500 rpm and the piston just melted maybe i can jb weld the holes in piston and sell it back to ya thanks cfs:cheers:

[baja200merk]

8500 thats it?

[phil blomquist]

pretty good on an engine stand don't know for sure though:smiletest: