WATERWINGS
08-27-2002, 11:36 AM
One of the lost posts was mine, but I can fill in a few blanks,
I noticed in the photo of the broken propshaft, posted by Techno,
that it was broken on the big side of the taper, I think I've seen a few like that. Mine is pitted on the small end of the taper, probably a worse place to have pits?
when I said I would put 200 parts in the CLE us1 said 200 shafts were 2 piece spun welded and could break easily when run on the surface.
At what spot do they break?
So I asked, how much should a used CLE propshaft cost? Does anybody have one?
I'll add more after some feed back
Thanks!
WATER WINGS
I noticed in the photo of the broken propshaft, posted by Techno,
that it was broken on the big side of the taper, I think I've seen a few like that. Mine is pitted on the small end of the taper, probably a worse place to have pits?
when I said I would put 200 parts in the CLE us1 said 200 shafts were 2 piece spun welded and could break easily when run on the surface.
At what spot do they break?
So I asked, how much should a used CLE propshaft cost? Does anybody have one?
I'll add more after some feed back
Thanks!
WATER WINGS