RC51
05-20-2008, 09:41 AM
Just purchased a Stainless Marine Trim and Jack indicator system. As you probably know the jack indicator set up is for there hydraulic jack plate. I have a CMC hydraulic jack plate. I purchased it from Stainless Marine and it had the instructions for the face plate and trim indicator set up. But, nothing for the jack indicator set up.
The guy from Stainless Marine, very nice guy, knew I had a CMC. He said people figure out a way to make there indicators work on other hydraulic jack plates all the time.
So, has anyone else done this? Could someone post a picture of there installation so I can figure this out. As long as I can see the installation I should not have a problem. Any advise would be appreciated.
Thanks
The guy from Stainless Marine, very nice guy, knew I had a CMC. He said people figure out a way to make there indicators work on other hydraulic jack plates all the time.
So, has anyone else done this? Could someone post a picture of there installation so I can figure this out. As long as I can see the installation I should not have a problem. Any advise would be appreciated.
Thanks