PDA

View Full Version : TRIM how high can i go??



stiletto200
08-20-2007, 09:21 PM
:confused:
Howdy all,
am wondering if i could go up a further hole on my transom bracket to get more speed.
'89 200 blackmax 16 ft swiftcraft stiletto
Have already blocked off the 3 top holes and drilled the lowers out to run engine higher but find i still have to trim it a bit to get max speed.
When I do WOT sprints the tell tail stops piddling but the guage has never shown hot and i know its accurate. Still have t-stats in, am presuming that the revs and bigger pick up holes are very efficiant and t-stats are working how they should,would this be correct?

terry taylor
08-21-2007, 07:42 PM
HI. This is difficult to answer, your saying trim and then engine height the two are different maybe rephrase could help thanks.

stiletto200
08-21-2007, 09:58 PM
sorry terry
im really asking 2 questions here
1 engine height for water pickup and water flow
2 more or less trim angle or raise the engine

Forkin' Crazy
08-21-2007, 10:06 PM
When I do WOT sprints the tell tail stops piddling

Do you mean the pisser stops? If you don't have a water pressure gauge, you need one!

stiletto200
08-21-2007, 10:42 PM
yeh the pisser does stop momentarily where ya rekn i could get hold of a pressure guage kit over here in aus???
how would you go bout fitn 1 to a 2.4 200???

Forkin' Crazy
08-22-2007, 12:07 AM
yeh the pisser does stop momentarily where ya rekn i could get hold of a pressure guage kit over here in aus???
how would you go bout fitn 1 to a 2.4 200???


I think there is a plug on top of the block? Not sure on a merc. I would think a dealership or marine supply would have one plus the instalation kit. Sounds like you need a low water pick up, torque tab, jack plate, and a surfacing prop. :)

hsbob
08-22-2007, 11:52 AM
just beside/under the volt regular is a 3/4 pipe threaded adapter to 3/8 hose[90 degree angle] cut that hose and put a tee in. run it to any 0-30 psi guage. get one at a hardware store for testing until you can find a dash guage. psi is psi so ant guage will work. a hardware guage should be under $10 us. guage kit about $60us.

stiletto200
08-23-2007, 12:20 AM
Thanx Heaps For The Info
Will Look Into It